View Single Post
Old May 6th, 2002, 10:33 PM   #3
Eric in Dallas
Guest
 
Posts: n/a
Re: Even on a lift you need a rubber arm

Jeff: do tell about the special tool. I put my long tube on, but my ordinary 11mm line wrench had very little up and down room - I got the valve cracked and bled, it was tightening it that was hardest - getting the wrench on the nut with enough travel room to ummmph it enough to where I was satisfied it was tight. I ended up using an ordinary open end/box end 11mm but a special tool sounds interesting!

We should start a 986 clutch bleed valve club - you have to show your arm scars to get in!
  Reply With Quote